Re: Power brake and standard trans.
Posted by HH56 On 2011/1/12 15:33:11
Not sure how much better angle I can get showing pedal. 2 above plus another here. In order to work with clutch and earlier pedal, these are dimensions available.
Clutch height should not be a problem as there is 6 1/2 inches clear between firewall and where I mounted the steel plate over opening 3/4 up at bottom.
The width is the issue and no one was able to give me any dimensions to work with. There is only 3 3/4 at left of shaft end to edge of opening. I don't know how far in the clutch comes.
The dimension from the transmission corner by accelerator to straight below new mount point to pedal is 10". If the earlier pedal is much different sideways, Heim joints will allow a slight offset in any direction but would not want it to be too much. Currently the pedal is 5" off floor which is a tad higher than normal.
Attach file:
(45.71 KB)
Clutch height should not be a problem as there is 6 1/2 inches clear between firewall and where I mounted the steel plate over opening 3/4 up at bottom.
The width is the issue and no one was able to give me any dimensions to work with. There is only 3 3/4 at left of shaft end to edge of opening. I don't know how far in the clutch comes.
The dimension from the transmission corner by accelerator to straight below new mount point to pedal is 10". If the earlier pedal is much different sideways, Heim joints will allow a slight offset in any direction but would not want it to be too much. Currently the pedal is 5" off floor which is a tad higher than normal.
Attach file:
(45.71 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=68537