Re: Compression Question

Posted by Owen_Dyneto On 2011/12/16 9:07:46

Paul, you can get a new proper gasket from Kanter Bros., Max Merritt, or Egge, among others. Cost is probably around $125, +/-.

Highly unlikely that retorquing the head bolts will solve the problem at this point, but it takes so little effort that it's worth a try. About 63 lb-ft should be correct; if all are loose, go in a spiral pattern starting in the center and go in a couple of steps. Or you can just use the pattern shown in the shop manual.

And don't forget after you install a new gasket, to retorque twice, once after 30 minutes or so of running, and again after a couple of hours. Wouldn't hurt to recheck again after a few months of service. If one or more refuse to tighten to torque, chances are the stud has fatigued and is stretching - replace it (or all of them).