Re: Fuel problem question old new guy

Posted by Tim Cole On 2012/2/6 19:54:51

Dear Jim:

Here is a quick method to clear dirty idle air bleeds that may be causing an idle problem:

Rev the motor to moderate speed and quickly place your hand over the carburetor. The suction will help clear any dirt clogging up the air bleeds. A little spray Gumout before this proceedure will also help.

I like that pinhole story. Make sure all of the lines and fittings are air tight. Restored cars suffer more from air leaks than original cars.

Also, those rubber lines crossing over the frame is lousy. You can get the Airtex inline fuel pump from Bill Hirsch which can be put on the outside of the frame.

Hope this helps