Re: Question relating to engine table

Posted by Owen_Dyneto On 2012/2/28 13:32:49

Remembering that this is a two-piece block and you'll probably work on each part separately and assemble them together when the crankcase is already in the car, you don't need to be too concerned about strength of the table. The bore section is the heaviest, two people can lift either section, though 4 would be better for the bore section. After the pistons are removed and the bore section removed from the crankcase, I lift the bores by laying it sideways, running a 4 ft. length of 2x4 thru #1 and #8, and use a person at each end - easy enough.