Re: Question relating to engine table

Posted by David Grubbs On 2012/2/28 17:13:50

As promised, here are some photos of my scrap wood worktable. I put a spare head on it for scale purposes. The table is 36" high. The timber frame on top of the later photos was used to hold the finished engine in a trailer for transporting to the shop for installation. The 2x4's underneath are dual purpose - to hold the pan off the ground, and to allow the frame to be screwed to the wood deck of the trailer. Total cost was about $15 for the casters and some star head screws. All the wood was in the scrap bin out back. Hope this helps. Just don't forget the cross bracing on the ends and the horizontal pieces on the bottom to keep the legs steady.

Attach file:

---

  (46.15 KB)


  (69.76 KB)


  (76.00 KB)


  (75.34 KB)


  (74.51 KB)