6 Volt battery cables
Posted by Jim McDermaid On 2012/4/17 19:35:26
I would like to know the official / original routing of the original 6 volt battery cables.
My 54 Cavalier is positive ground.
I believe the ground cable was actually flat heavy copper braided cable and probably dropped down and bolted to the frame although I don't see any obvious holes.
I would expect an equally heavy strap to tie the engine block to the frame somewhere.
The negative probably went fairly direct to the starter solenoid switch.
This said, Back when I first bought the car last year I made some new battery cables (heavy gauge flexible wire from an old RCA Television transmitter) replacing the 12 volt #1 gauge battery cables that were in there.
I will say the new heavier gauge wire cranks the starter a whole lot faster than the previous #1 cable. Having less voltage drop through the cables means more voltage for ignition.
I have now acquired heavy gauge flat cable and I'm ready to take the step.
Original battery clamps were a slightly different size, anybody know where I can get originals made of brass or copper?
Thanks,
Jim
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=99326