Re: Hood vents
Posted by humanpotatohybrid On 2022/7/10 7:27:53
Quote:
I don't think you will get anything much better than that. The equipment used for that is six figures and even the cost of the metal itself I would think would be $100 per part.
Also keep in mind that any 3D printed stuff (metal or otherwise) will have quite a rough texture to it. I would ask, but you will probably need to run them for a while thru a vibratory finisher.
Expect that right off the printer it will look something like this:
The cost of scanning and printing for each as quoted is $200 US, I am trying to negotiate a better deal.
I don't think you will get anything much better than that. The equipment used for that is six figures and even the cost of the metal itself I would think would be $100 per part.
Also keep in mind that any 3D printed stuff (metal or otherwise) will have quite a rough texture to it. I would ask, but you will probably need to run them for a while thru a vibratory finisher.
Expect that right off the printer it will look something like this:
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=245761