Message sent of parts wanted

Thank you, Jerry

Are these the short ones that are used with side mounts and fender skirts?

I have an extra wheel, measure the center hole and let me know what it is. I carried this around in my 42'120 convertible for 25 years and then I found out it would not fit . and I have been told it fits Clipper series cars. I may have to find a couple of the clips as I removed the ones that were not rivited on


Free if you pay for shipping

Jerry

Attach file:

---

  IMG_8734.JPEG (203.50 KB)


  IMG_8732.JPEG (332.06 KB)

It’s a 1942 senior series. You can tell it’s a 42 by the front side grills and it’s a senior series by the hood side latches

Sent you a message

As I do the body work on my 1942 120 convertible I am ready to weld up the old double antenna mounting holes and re-drill for the correct antenna.

Looking for the measurements from the belt line molding down to where the antenna should mount

Attached is a picture of the existing antenna

Any insight or pictures would be helpful

Attach file:

---

  IMG_6296 (2).JPEG (88.51 KB)

Pm sent

Here are some pictures of the transmission
It all came out of a 42 but I do not think either of them were original to the car

Attach file:

---

  29DAB913-E427-42B8-A2FC-AF6890B68077.jpeg (356.54 KB)


  830D26AF-7DFE-487F-8261-DC107122C8EE.jpeg (570.84 KB)


  08AF7017-17D7-4CC4-94CB-D4E6E87F096C.jpeg (568.32 KB)


  47DEBC20-E882-493E-B108-F0EBBDE66C94.jpeg (413.30 KB)

Engine is sold, transmission still available

Sent you a private message
Thanks, Jerry