|
Re: Torque specs
|
||||
|---|---|---|---|---|
|
Just can't stay away
 
|
Thank You
Posted on: 7/19 19:51
|
|||
|
||||
|
Torque specs
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
Can anyone give me the Torque specs for the fly wheel and clutch on a 1941 160
Thank You
Posted on: 7/19 17:28
|
|||
|
||||
|
For Sale 1956 Packard Caribbean
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
1956 Packard Caribbean Convertible. This Caribbean is number (2) of 276. Number (1) is reported to be in Sweden. The top has been replaced; new tires; original dashpad has been peeled back, repadded and rei[size=small]nstalled. Original paint with flaws; original interior; no rust; stainless steel strips have been replaced with NOS. Paint color is MTV; chrome is very good; original 2/4 setup; motor and transmission have been gone through; power steering, power brakes and TL system all work. Car is in Virginia. For additional details and pictures, call Bob (804) 389-2555 or email rlplkp@comcast.net. $65,000
Posted on: 1/17 11:00
|
|||
|
||||
|
The New Super Eight Oil Pump
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
The Packard Service Counselor Vol.21, No 2, page 6, refers to an updated oil pump (Part number 387862), casting #387756 for the 18th through 21st series cars. Is anyone using these updated pumps with good results?
Thank You, Bob
Posted on: 2022/2/2 20:07
|
|||
|
||||
Updated Oil Pump.pdf|
PACKARD TECNICAL CHARTS
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
1953 --- 26th Series Supplement
37 Pages 38 inches long 25 inches wide $250.00 Attach file:  Wall Chart - 1.JPG (688.66 KB)
Posted on: 2021/12/2 20:59
|
|||
|
||||
|
Packard 1921 single six oil level
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
Manual states Oil Capacity Crankcase on single six is 2-1/4 Gal then states Additional oil over level necessary to make rods dip is 1 1/2 gal
Does that mean a total of 3-3/4 gal total in the Crankcase ? Thanks
Posted on: 2021/4/29 20:58
|
|||
|
||||
|
Re: Oil pressure at 10 psi
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
Thank You All I will take it from there Bob
Posted on: 2021/1/24 10:53
|
|||
|
||||
|
Re: Oil pressure at 10 psi
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
10 psi IS FROM A MANUAL GAGE AT THE BLOCK
owner IS DECEASED REBUILD WAS 15 YEARS AGO
Posted on: 2021/1/23 17:04
|
|||
|
||||
|
Re: Oil pressure at 10 psi
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
Oil is 15-40
New rebuilt oil pump was installed Can has not been driven due to low Oil pressure and no change in pressure on fast idle No bottom end noise yet, some top end noise
Posted on: 2021/1/23 11:45
|
|||
|
||||
|
Oil pressure at 10 psi
|
||||
|---|---|---|---|---|
|
Just can't stay away
|
Purchased a Packard with a "rebuilt" 288 engine Oil pressure at engine is 10 psi
any ideas what they did not do or left out? Thanks
Posted on: 2021/1/22 19:39
|
|||
|
||||
