aftermarket auto trans,cooler
|
||||
---|---|---|---|---|
Not too shy to talk
|
anyone run a aftermarket auto trans,cooler on there twin ultramatic trans, if so what size,thanks
Posted on: 2017/8/6 19:48
|
|||
|
55 engine number location
|
||||
---|---|---|---|---|
Not too shy to talk
|
1955 clipper custom constellation can.t seem to find the engine number i have looked in all suggested place's front behind the water pump ,back by exhaust manifold , am i missing some thing ,also what color should the engine be ,it looks turquoise,with black valve cover stamped packard ,there is is a dark emerald green paint under the turquoise ?
Posted on: 2017/8/3 18:28
|
|||
|
Accel trans fluid
|
||||
---|---|---|---|---|
Not too shy to talk
|
anyone use accel type A trans,fluid,if so what where the results,thanks
Posted on: 2017/7/28 8:36
|
|||
|
Re: 55 clipper sending unit gasket?
|
||||
---|---|---|---|---|
Not too shy to talk
|
not sure if it is and o ring or gasket have not removed it yet,wanted one so when i take the tank out to clean it,
Posted on: 2017/7/25 19:33
|
|||
|
55 clipper sending unit gasket?
|
||||
---|---|---|---|---|
Not too shy to talk
|
does anyone know where to get a fuel sending unit gasket/retainer seal , for 55 clipper, or part number from cross ref,thanks
Posted on: 2017/7/25 12:24
|
|||
|
sheet metal or patch panels for rear quarter 55 clipper
|
||||
---|---|---|---|---|
Not too shy to talk
|
Does anyone know where rear quarter patch panels can be purchased for a 2 door clipper,or just the lowers between the door and wheel well,thanks
Posted on: 2017/7/17 12:13
|
|||
|
Re: 1955 packard clipper hood stuck closed
|
||||
---|---|---|---|---|
Not too shy to talk
|
thanks to every one for there ideas on how to get the hood open,come to find out it was not the bayonet but the secondary latch ,some how it got bent enough so i could not pull hood release lever over.had to pry lever over with a bar and push and pull up and down on hood until it released .once opened i was able to straighten out the latch, works great now.
Posted on: 2017/7/13 15:30
|
|||
|
1955 packard clipper hood stuck closed
|
||||
---|---|---|---|---|
Not too shy to talk
|
just purchased this 55 clipper custom a short time ago ,started by changing fluids, brake repair , carb. repair fuel pump, you know the grind ,well the hood would not latch so oiled latch did some slight adjustments on the bayonet .and it closed great ,only problem can't pull hood release back far enough to release hood ,any you run in to this problem, thanks in advance
Posted on: 2017/7/11 11:14
|
|||
|