johntrhodes81	Re: PS Control Valve Leak	#131
Home away from home	One of the PS hoses between the Control Valve and the Ram has metric fittings, 11mm. Does that mean it was replaced sometime? Thanks, John Posted on: 2019/6/6 21:20
	John Rhodes 1953 Packard Patrician

johntrhodes81	Re: PS Control Valve Leak	#132
Home away from home	Howard, Thanks so much. I will try that. I assume take it apart 1st and go from there on repair or get a rebuild. Thanks, Posted on: 2019/4/20 21:58
	John Rhodes 1953 Packard Patrician

johntrhodes81	PS Control Valve Leak	#133
Home away from home	I have a 53 patrician with power steering. My control valve is leaking from the ball stud. The 51-54 Packard Service Manual says to recondition the control valve assembly. Where do I get parts to do that? Thanks for any help. John Posted on: 2019/4/20 21:34
	John Rhodes 1953 Packard Patrician

johntrhodes81	Re: 1952 327 Connecting Rod Help/Suggestions	#134
Home away from home	Thanks! John Posted on: 2019/4/1 18:58
	John Rhodes 1953 Packard Patrician

johntrhodes81	Re: 1952 327 Connecting Rod Help/Suggestions	#135
Home away from home	The 359 had bigger intake valves than the 327. Exhaust were the same. Did the block casting get changed to fit the bigger valves or just machining? John Posted on: 2019/3/25 13:34
	John Rhodes 1953 Packard Patrician

johntrhodes81	Re: 1952 327 Connecting Rod Help/Suggestions	#136
Home away from home	Does anyone know if the wall is thin around the exhaust valve as well? The cross section picture was described as an intake valve. Thanks, John R. Posted on: 2019/3/21 22:09
	John Rhodes 1953 Packard Patrician

johntrhodes81	Re: Bendtsen Straight 8 Transmission adapter	#137
Home away from home	How did it turn out? How did the driving improve? Would you do it again or differently? Thanks, John R. Posted on: 2019/3/19 5:50

johntrhodes81	Re: Craig's Panther Project -- Sway bars	#138
Home away from home	Craig Do you think this would be much different on a 51 to 54? I have also heard Chevy II bars work at least in the back. Also do you find the 1" front 3/4" rear to work well? Or would bigger or smaller have been better? Thanks John Posted on: 2019/3/14 19:15

johntrhodes81	Re: Disc brake install	#139
Home away from home	Should this work on a 51-54 as well? Thanks, John R. Posted on: 2019/3/13 5:45

johntrhodes81	Re: Packard rear end gear ratio and LSD/TT	#140
Home away from home	The interest in an LSD was for traction but only secondary. But my real interest was higher numerical gears as part of changing the trans to a modern automatic overdrive unit. Maybe a 0.70 overdrive 4L65e or other. John R. Posted on: 2019/3/12 13:14