Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
the clock contacts.https://youtu.be/5BBUEA1yZLI
Posted on: 2016/7/4 3:03
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
Posted on: 2016/7/3 18:13
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
have all shifts,
only can test in driveway, using wal mart type F, up grade later, with lubriplate,
Posted on: 2016/6/23 20:44
|
|||
Riki
|
||||
|
Re: headliner bow grommets
|
||||
---|---|---|---|---|
Home away from home
|
looks like the tire valve stems are the way to go, they are 3/4" OD, same valve stem used for Packard rims, the large ones,
cut 4 going to try them tomorrow, 6-24-2016
Posted on: 2016/6/21 0:54
|
|||
Riki
|
||||
|
Re: headliner bow grommets
|
||||
---|---|---|---|---|
Home away from home
|
thanks, h,
didn't think of that, I made some with standard grommets, with another rubber flat piece, with a 1/4 inch hole, it works, but , does not support end of rod that good, the hole is 11/16ths, I was at autozone today, and there was a PVC grommet that had that taper end on it, but, inside hole to big, Toyota,
Posted on: 2016/6/20 19:36
|
|||
Riki
|
||||
|
headliner bow grommets
|
||||
---|---|---|---|---|
Home away from home
|
anyone know where you can get the grommets for the headliner bows
55-56 400,,4 doors are different
Posted on: 2016/6/20 19:03
|
|||
Riki
|
||||
|
Re: Pinion Seal
|
||||
---|---|---|---|---|
Home away from home
|
pm. troy, he might know
Posted on: 2016/6/20 1:33
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
edit,,
enlarge picture number 2,
Posted on: 2016/6/16 14:29
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
v8.
I used the braid to join the 2 pieces, it broke in the curve ,stress point, I could of soldered to the contact side then bolt to case, which might better, but it works,,
Posted on: 2016/6/16 14:26
|
|||
Riki
|
||||
|