let me find it, there is a service post on it, it shows how to file it

the part that the seal goes on ,,did you check if the inside was filed?,, this lets oil in so plates don't burn,

EDITED,,

bottom part

I only have used,,,

kev,,really, lock washers!,,

give me the size I can make those spacers,,,,,

you should get with peter fitch, and get the shift lever, and parking pawl made out of metal.

Pac sw found this
Stude boot..6 bucks ebay.

Bought it.

Attach file:

---

  (118.53 KB)


  (75.96 KB)


  (72.65 KB)

could a speedo cable work to replace nylon?

that's what I have been thinking,, from your comments,

easy,

so I will see about casting, about how many if they ask?, 100?,

but going for one first, see what that cost is,

I was looking at swapping regulators, with the dorman,

I am going to set up a test board, with plywood, with a tension spring on regulator ,, this way you can watch what's going on,

h,

out at pac sw, got more info, and reg, I am thinking now to remove the bracket,

and use that gear on the motor, think I am going to put it on plywood, to get things placed, and run it,,before putting it on door,

going to take that Teflon one to see what it would cost to cast,

I saw some oil gears that might work