Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
bell housing needle bearing, oil return hole.
Posted on: 2015/9/13 11:55
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
55-56 band shafts, -used chrome molly, didn't want the finish on the g8 bolts to rub off and get in the oil.
Posted on: 2015/9/11 18:32
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
band shaft,,chrome molly,,didn't want the yellow or black finish to rub off, that is on the g8 bolts and get in oil.
Posted on: 2015/9/11 18:29
|
|||
Riki
|
||||
|
sb 350
|
||||
---|---|---|---|---|
Home away from home
|
well...
Posted on: 2015/9/7 21:29
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
band shafts,,grade 8 bolt,,low band,,, reverse band has 3/8 shaft, doing next...
spacers to center lever.,,,no groove in bolt, except at roll pin
Posted on: 2015/9/7 21:14
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
shaft spacers,, broke end mill trying to slot shaft,,so put it in lathe,,it for roll pin
Posted on: 2015/9/7 21:12
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
chrome moly another option, but they don't have it in 3/8s,
going with the g8 bolt, if, Packard would of used the shaft for low,brake, think they would be ok, its, 1/2 inch, the reverse is 3/8s, then you have that groove, not enough room in case to ream out to 1/2 inch/ spacers to center lever, see what I have around here ,,hot roll should be ok, might have 3/4 stainless, to get fancy, could put needle thrust washers on the sides,,,,
Posted on: 2015/9/7 15:41
|
|||
Riki
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
|
my dads fix,, lever
Posted on: 2015/9/7 2:20
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
had a g8 bolt
Posted on: 2015/9/7 2:17
|
|||
Riki
|
||||
|