Thank you sir. As always, you had the answer!

Greeting! I need to replace the shifter mechanism s on my 53 Clipper. In order to do that, I understand that the steering wheel needs to be removed. I am looking for instructions on the process to remove center cap and steering wheel. Thanks in advance. Steve

Still looking for a rear drum that is serviceable. Thanks

I have 12s. Where are you located? What are you asking?

Let me check what I have and I will get back to you

Need a replacement rear drum for
My 53 Clipper. Any one have a parts car?

I have the two flex lines for the front. Need the rear. Is the rear the same as the front flex lines? Has anyone crossed these to a more recent application? Thanks in advance. Steve

Rebuilt master cylinder plus replaced rear axle seals. Adjusted rear shoes. Brake lines fully open. I benched primed the master cylinder. Squirted 1/2 way across the garage. Had a vacuum brake bleeder that I thought I would try. Worked half way...still no brake pedal. I use to have a helper pump three times and hold. Work from farthest wc from master cylinder to the closest wc. Does that work on Packards? Looking for suggestions. I am using Dot 4 fluid

I was going to use dot 3 to service my brake system. Notice that I have synthetic dot 3. Is that ok to use? Or should I find non-synthetic?

Also what is recommended to use on the star adjusters for the brake shoes? Looking for something to use as an anti seize for that.

Thank you Howard. My manual did not have that set of pictures. Perfect!

Steve