Re: Tune up
|
||||
---|---|---|---|---|
Just can't stay away
|
You could always pull the plugs (or a few) and check the conditions of the carb mixture . Usually that’s a great tell tale sign of if it’s rich or lean . I’d like to check the accelerator pump operation . Maybe a missing pin or clip on the carburetor ?
Posted on: 2021/8/27 5:31
|
|||
|
Transmission chatter
|
||||
---|---|---|---|---|
Just can't stay away
|
Hi everyone , back again so another question on my 22nd
Driving it - runs, shifts , stops great ! Everything is going great . Step on the gas it goes !! Runs like a sewing machine BUT …….. Slowing down however there is a chatter almost as if a “brake shoe has came loose” type of chatter ONLY freewheeling and in gear . Push it up out of gear , sound stops . Clutch out or in no change .
Posted on: 2021/8/24 20:21
|
|||
|
Re: 1948 Packard not starting
|
||||
---|---|---|---|---|
Just can't stay away
|
I’d pull the head , clean it up make sure valves aren’t stuck open . Compression doesn’t have to be high ,as much as consistent across all 8 holes . Like 5 psi difference with all 8 . Good luck !!
Posted on: 2021/8/17 20:15
|
|||
|
Re: Junkyard Packard photo
|
||||
---|---|---|---|---|
Just can't stay away
|
Old car still looks pretty straight from just looking at it .
Posted on: 2021/8/3 10:56
|
|||
|
Re: Wiring question
|
||||
---|---|---|---|---|
Just can't stay away
|
Wow thank you Howard !!
Yea I’m sure I have the updated OD system I can tell by the schematic it’s much simpler than previous . I’ll be working on my cable then we’ll see what happens . Thank you so much again !!
Posted on: 2021/8/3 10:55
|
|||
|
Re: Wiring question
|
||||
---|---|---|---|---|
Just can't stay away
|
Hello Howard ,
I understand this wiring diagram you showed me . But what exactly is this one I have ? See below
Posted on: 2021/8/3 9:35
|
|||
|
Re: Wiring question
|
||||
---|---|---|---|---|
Just can't stay away
|
Ok so I found more clues as to what is going on . The OD cable has came out of the “handle” inside the car and appears to be in the pulled position but the knob itself is all the way in . Also the two wires on the lockout switch are both unhooked from the knob as well .
Posted on: 2021/8/3 8:50
|
|||
|
Re: Radio hook bolt
|
||||
---|---|---|---|---|
Just can't stay away
|
Thanks , that should put me on the right track 👍👍
Posted on: 2021/8/2 18:39
|
|||
|
Radio hook bolt
|
||||
---|---|---|---|---|
Just can't stay away
|
Anyone have a visual on the hook bolt for a radio bun my 22nd ? I assume it’s 1/4” thread but like to know what exactly kind of hook is on the end ? Length as well
Thanks guys !!
Posted on: 2021/8/2 17:11
|
|||
|