I made a long bar attached to yoke.

To hold it. Dealing with 200 ft lbs.

Attach file:

---

  4498_5f0925f4ceb5e.jpg (249.74 KB)


  4498_5f09261477bbf.jpg (269.83 KB)

Big in the 70s.

Some old hot rod posts should give yeah or nay. .

Replaced in car.

Don't know what I did with 2 pole.

But found these 3 pole spdt ones. I had

Ground off 3rd pole.. the throw isn't as pronounced as other switch.

But it works.

Of coarse. The switch I removed. Works when it's out. Something is up with it.

Attach file:

---

  20240225_170007.jpg (4,092.38 KB)


  20240225_153512.jpg (3,417.68 KB)

My L.

Micro switch gave up. Delima. Pull the wires thru column or replace in car.

Ugh.

Attach file:

---

  20240225_133101.jpg (3,126.50 KB)

Until you come to California..

Thanks Don.

Ignition trouble again

Moving coil off intake.

Then. Pertronics is confusing.

They say you can keep ballast. Then with their coil. Take it out.


So leaving pink Packard wire out. Jumping 12 volt from Ignition.

Talking with hh56 pretty sure my issue is the ballast..

After start up Pertronics is only getting 6 or 8 volts.



Edit..


Don't know ohms of delco coil.

M

Attach file:

---

  20240217_202432.jpg (3,522.05 KB)


  20240217_174538.jpg (2,897.90 KB)

Straight

Or mix up trans and diesel oil. Wet it down.

H

Isn't there magnets that work the needle

Not there myself.

But my dad's 36 is apart

And from I have seen its like a regular clutch.

Just HEAVY.

I can that picture tomorrow. To show inside pressure plate.