I’m sure there are many ways to attach the mirror to the housing. I have had the best luck with 100% silicone. If it’s off the car apply silicone in the housing. Enough so when the mirror is in place there is contact. Then flip the housing over on a flat surface so when it dries the edges of your mirror will be flush with the housing. If it’s on the car silicone some shims in place and dry fit the mirror so it flushes out. Add more silicone over the shims and to the housing. Set mirror In place and tape from back of mirror housing over the mirror to the other side. Tape it vertical and horizontal. If you leave out this last step you will be breaking out a sagged crooked mirror the next day. And now my thumbs are tired! Hope that helps.

need a little more info. im assuming hood louvers? what year and model.

Mark I have the latch your looking for. call or message me . Mike / Tucson Packard

Hey Nick i sent you a PM

I have brake drums for you. 520-336-0057

I bought six cars from the last auction. I agree the fees are a little on the steep side, but they did accept the wire transfer as cash. It may have been from my complaining, but I found them easy to deal with.

I Have one. You can call me at 520-336-0057
Mike Chirco/ Tucson Packard

I have a good main shaft assembly you can have for a site donation as well.

If you haven't found it yet i have them in stock
Mike Chirco/ Tucson Packard

Hello, I would be willing to come pick it up. Mike 520-336-0057