It will only go one way-if the bolts don't line up, turn 180 degrees. Good luck

you might check ebay 260952889973 for complete new cable, just make sure it is 87.5 inches long for overdrive trans. price is 35.00 plus shipping Dell

i have a 14 inch long scraper with a 1/4 end that i use to pry from one side to the other, also might try slide hammer. i have never had to much trouble getting one out. dell

mark the drive shaft yoke nut in relation to the threads after the drive shaft is out (very important as it is the preload on the pinion bearings) use punch to mark. remove the nut and you are at the seal- the seal can be removed from the larger metal ring that holds it (i can give you the # 0n the 8th if you need it) old original is 50066, if your auto supply has the old books they can find the new #. you must be very care full when you remove the metal seal holder, if you mess it up, you need a new old stock or one from max merrett. put sealer on the new seal when you press it into the holder (i use a vise) and sealer on the metal when you replace it. replace the nut to the marks plus just a little more stake it in several spots with a center punch or it will come loose. good luck Dell

Wellcome to the woodie club; I am putting my 48 back together every day-check the registry under 2293. I belong to the national woodie club and will e-mail you the info, they have lots of adds for wood restoration people.

I have a carter book with all the info. If you give me your motor number and an e-mail I will give you the the correct info. I might have a core also, glade to help.

works best if you take the glove box out, remove the heater distribution tube and unbolt the heater control under the dash. two nuts on top and j bolt on bottom of the radio - if you need more room you can undue the switch bar by removing two special nuts that are about an inch long (be very careful if you still have the old wiring. Its a big job-you just have to remove whats in the way. my custom is the black one under 2259

the c/r 3060 worked great in my r9,just knock out the old seal and washer and pop in the new- have fun

i have a number for a replacement seal, not much money. i will try to remember to get it for you tomorrow-it worked great on my custom.

call max merrit and make sure they take one to hershey-i am almost positive fred has them. if not let me know-mel