Re: edelbrock carb on 55 clipper
|
||||
---|---|---|---|---|
Not too shy to talk
|
so 1406 is bolt on ,did you use elect choke .will a 1/2 inch thick or 1 inch spacer be to much . thank you
Posted on: 2018/5/18 12:23
|
|||
|
Re: 1956 clipper throttle spring
|
||||
---|---|---|---|---|
Not too shy to talk
|
thank you this was very helpful
Posted on: 2018/4/28 11:45
|
|||
|
1956 clipper throttle spring
|
||||
---|---|---|---|---|
Not too shy to talk
|
any one have a diagram of how the throttle spring or springs are attached and located ,car has auto trans, it looks like it might have been attached to fire wall ? someone before i got the car .put a spring from intake to throttle linkage,does not work well.thanks
Posted on: 2018/4/27 10:05
|
|||
|
clips for outside trim
|
||||
---|---|---|---|---|
Not too shy to talk
|
any vendors selling the steel clips for the outside chrome?where can the spring type used on rocker chrome be found,thanks
Posted on: 2018/4/22 7:32
|
|||
|
Re: ballast resistor
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks just what i was looking for
Posted on: 2018/4/21 18:13
|
|||
|
ballast resistor
|
||||
---|---|---|---|---|
Not too shy to talk
|
any one know how many ohm should be going through the ballast resistor on 55 clipper cold or hot .thanks
Posted on: 2018/4/21 8:44
|
|||
|
Re: 55 clipper ignition switch
|
||||
---|---|---|---|---|
Not too shy to talk
|
thanks for the help i;ll be checking out napa auto for sure
Posted on: 2018/4/17 10:53
|
|||
|
55 clipper ignition switch
|
||||
---|---|---|---|---|
Not too shy to talk
|
anyone put a after market ignition switch in there 55 or 56 clipper what brand did you use,
Posted on: 2018/4/15 18:42
|
|||
|
Re: 55 clipper hinge pin
|
||||
---|---|---|---|---|
Not too shy to talk
|
sorry i should have been more specific on what hinge . passenger door on 55 hardtop clipper,I thought some of you may had run in to this problem and knew what pin set could be used for this repair ,hard to believe that because it packard that pin size would be rare or odd size .thanks for info.
Posted on: 2017/9/5 9:22
|
|||
|