Complete except side stainless. Interior front floor and rockers need patches only. Inner rockers, lower A pillars and trunk floor are solid. Engine stuck. R9 O/D. Extra parts included. Make an offer. SE Michigan. Dan 73four-six78-11four4. Has to go by Memorial Day.

Deluxe based project. Chassis is done with new brakes, suspension bushings, driveshaft, and exhaust. 148" wheelbase. Engine runs. R-11 O/D. All parts to complete assembly included, plus extras.
Make an offer. SE Michigan. Dan 73four-six78-11four4. Has to go by Memorial Day.

Yes. What are you interested in?

Modified GM HEI with centrifugal and vacuum advance fits straight Packard. 12 volt plug and play.
$150. plus shipping

Dan
73four-six78-one144

I need some shelf space so this stuff has to go:
8 rod bearings, Packard 394407, -.020 under, NEW, $15 ea.
Main bearing set, Clevite, -.010 under, NEW, $80.
with crankshaft, ground, polished and balanced, .010 mains, .020 rods, $100.
Cam bearings, EGGE PA-4, NEW, $40.
Brass core plug set, $20.
Valves, full set, Packard, reconditioned, $5. ea.
Oil pan, USED, $25.
Oil pickup and screen, USED, $25.
Oil pump, good USED, $25.
2 Crankshafts, USED, never ground, $50. each
Head, cast 6-13-48, USED, 50.
Head, Thunderbolt, cast, 7-17-53, USED, $50.
Set of good manifolds with Carter WDO core, $100.
2 water distribution tubes, Good USED, $100. ea.
2 reground camshafts, $100. ea.

Set of intake/exhaust flanges to fabricate tubular manifolds, 3/8 thick laser cut steel, NEW, $100.

located in SE Michigan
Heavy stuff pickup only, Shipping is extra on others

Dan

Joel can vouch for me...
73four-six78-1one44