I didn't put the year and model because this is going on a custom 1932 Packard "Dietrich inspired" body we are building in the shop. The strips were made by packardtwelve.com but they don't carry them anymore. That's why I attached a picture of what we are looking for. Do you know what these fit so I can add it in the subject title?

We are looking for this style of running board trim for a Packard we are working on in the shop. Must be 66'' long. We have already contacted packardtwelve.com with no luck. Any leads would be appreciated.

Attach file:

---

  Trim.jpg (217.36 KB)

Hi everyone, looking for a 1931 Packard Standard Eight water manifold that's in better condition than this one. Any leads would be great. Thanks!

Attach file:

---

  20241226_155136.jpg (608.03 KB)


  20241226_155125.jpg (860.63 KB)


  20241226_155114.jpg (750.33 KB)

Thanks Kevin for saving the day! Yes, these are for Dezi's car. Dezi, can you please pick these assortment of clips from Kevin and give them to Chad so he can go ahead and install your running board trim on your car. Thanks!

Hi everyone, the mechanic at our shop is installing the chrome running board trim for a customers 1937 120 and the clips that were purchased from Max Merritt don't fit that great. Has anyone used any other clips for their car and if so could you please share where you purchased them from? Thanks!

The center piece is now on. It was a pain but with the help of Jeff and Sam we were able to get the job done.

Attach file:

---

  hood1.jpg (242.08 KB)

That's an awesome photo! Thanks for sharing this

Thanks Dezi! Sorry, I would have asked Chad but he was not around

Hi everyone, working on a 1937 Packard 120 and we are ready to install the new piece of stainless trim piece on the hood from Max Merritt Packard parts and we have a few questions:

Does the stainless piece slide in from the front?

Does the end cap on the stainless piece face the front or the rear of the hood?

Here are a few pictures of what we are talking about

Thanks!

Attach file:

---

  hood.jpg (298.18 KB)


  trim1.jpg (427.22 KB)


  trim2.jpg (270.40 KB)

Hi everyone, we are putting together a 37 120 4 door and we are having a hard time figuring out how the rear ashtrays are installed below the rear 1/4 window. We have the wood trim piece and the chrome tray that goes in it but that's it. Does it need a bezel or bracket to install it on the door card?