Larry Nice tool set. The only tool missing is the ballpein hammer that would have come with the basic tool set.The jack does appear to be an earlier Packard jack.

The above is correct for most 51 thru 54 Packards,
however a lot of the senior
models had a different jack. You may have gotten
one of these. If so it will be ok.

The 351257 was a 1940 only bumper jack.It came with the 110's and 120's.
The 1941 Packards came with the hub which included the jack stands. Two different stands were used. One for the Junior cars and another for the Seniors. The 41 & 42 Clippers came with rim jack and included the junior jack stand.

Dan
PM about the bumper jack for your 49
Thanks, Don

The hooks on the 51 thru 54 are not detachable. Only the 55 and 56 were.
Also Packard used two different jacks in 51 thru 54. The one pictured in the comments above and a heavier one made by Walker for some of the senior cars.

The jack boxes are no longer produced by me. The die was over 600 dollars to have made. Didn't have a place to keep it. The boxes are identical to the original Packard ones. For years 48 thru 56. I still have some from the last run I had the factory due. Still
$25 and I can bring them along to the National Meet next week in Columbus if anyone should want one. Also have the jack decals for the 46 thru 56 Packards. Will be selling out of the jacks I bought to produce the Packard Jack and Tool book. PM me if you have any interest.. Thanks.

I am away from home. Will check to see if I have the bumper jack you need when I get back.PM in a week so i don't forget.I am clearing out my collection of Packard jacks. Thanks

All Packard Indoor Parts Meet is in Frederick Md. this weekend, Friday the 12th and Saturday the 13th. Lots of parts
and a few nice Packards for Sale. Car show both days.

All the above are true. But as I stated in the above reply you could get a full set of tools when you picked up your new Packard. There was about a dozen or more tools in the big set plus grease gun and tire pump available from the dealer.

Will

The basic tools that came with the 1936 120's was the hammer, screwdriver, pliers and the 9" adjustable wrench. These were in a pouch and were in the trunk with the jack etc. The pouch was reproduced but are no longer available. You could get a full set of tools from the dealer when you picked up you new Packard. These are listed in the parts list. I collected Packard Tools and Jacks for 25 years and have been clearing them out. Will try to attach a picture of the 36 tools .

Attach file:

---

  (183.23 KB)