Re: looking for lwb body trim
|
||||
---|---|---|---|---|
Just can't stay away
|
That would be awesome how do I contact you to purchase them
Posted on: 2018/10/3 19:38
|
|||
Mike
|
||||
|
Re: Looking for 49 hubcaps
|
||||
---|---|---|---|---|
Just can't stay away
|
Yes mine has a divider window
Posted on: 2018/7/24 19:32
|
|||
Mike
|
||||
|
Re: Looking for 49 hubcaps
|
||||
---|---|---|---|---|
Just can't stay away
|
Here are a few pics,I don't mind painting them I needed to do that on my other lwb
Posted on: 2018/7/24 17:48
|
|||
Mike
|
||||
|
Re: Looking for 49 hubcaps
|
||||
---|---|---|---|---|
Just can't stay away
|
Yes the front one is correct, they are for the 6" wide wheels so the inside and outside edge need to be even across on the back side I will post a pic of the back side when I get home
Posted on: 2018/7/24 15:17
|
|||
Mike
|
||||
|
Looking for 49 hubcaps
|
||||
---|---|---|---|---|
Just can't stay away
|
I bought a 1949 packard limousine over the weekend, and it has the wrong hubcaps on it.I am looking for a two that fit the 6" wide wheels,any help would be appreciated
Posted on: 2018/7/23 21:20
|
|||
Mike
|
||||
|
Re: Debi's 1953 Patrician
|
||||
---|---|---|---|---|
Just can't stay away
|
I used Dicks speedometer in Tempe and had nothing but problems and was very unhappy. They were expensive and it doesn't even come close to reading correctly.
Posted on: 2017/2/2 14:29
|
|||
Mike
|
||||
|
Re: valve guide damage
|
||||
---|---|---|---|---|
Just can't stay away
|
The machine shop gave me a refund for their work,but I am still out the money for the cost of the block,the valve guides,and the 130.00 to have it acid dipped.I have a 288 that smokes a little but seems to run good. I think I will put that in the car for now, until I decide to build another 327, Thanks everyone for your support
Posted on: 2015/6/17 13:08
|
|||
Mike
|
||||
|
Re: valve guide damage
|
||||
---|---|---|---|---|
Just can't stay away
|
Thanks for the info, I also noticed there is a intake valve guide where there should be a exhaust guide will that make a difference? The engine is a 327 are the 288 blocks the same if I use my crankshaft and head.
Posted on: 2015/6/14 12:11
|
|||
Mike
|
||||
|
valve guide damage
|
||||
---|---|---|---|---|
Just can't stay away
|
I had a local machine shop replace my valve guides,in the process they damaged my block. Should I still use this block or try finding another,I have a lot invested in the machine work and new parts for this one.
Posted on: 2015/6/13 22:02
|
|||
Mike
|
||||
|