Re: Brake Lights staying on
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks I'll try those. Do the brake lights work with the car off and key out
Posted on: 2021/6/10 16:36
|
|||
Thanks Brian
|
||||
|
Re: Regulator
|
||||
---|---|---|---|---|
Not too shy to talk
|
Hi I contacted Precision and they wanted over 600 to convert regulator, more than I'm willing to spend. Does anyone have a part number of one that will work. I have been looking and I get conflicting info, one site says it will work another says it won't. I would still like to go solid state if possible and it does not have to look like original Thanks.
Posted on: 2019/8/25 11:42
|
|||
Thanks Brian
|
||||
|
Regulator
|
||||
---|---|---|---|---|
Not too shy to talk
|
Hi Does anyone know if a Echlin VR-23 regulator will work on my 51-200, 288 with original 6 volt delco system? Also are there any electronic regulators that would work? Thanks
Posted on: 2019/8/13 22:38
|
|||
Thanks Brian
|
||||
|
Re: Charging voltage
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks Howard will charging at 8 volts hurt anything?
Posted on: 2019/6/11 0:07
|
|||
Thanks Brian
|
||||
|
Charging voltage
|
||||
---|---|---|---|---|
Not too shy to talk
|
Hi I just checked the charging voltage on my 51 deluxe 200 and it seems high. When I check with multi-meter and the car running it's showing 8 volts. If this is to high what should it be? Thanks
Posted on: 2019/6/10 22:27
|
|||
Thanks Brian
|
||||
|
Seat Covers
|
||||
---|---|---|---|---|
Not too shy to talk
|
Hi Does anyone know where to get seat covers for my 1951 200 touring sedan? Thanks
Posted on: 2013/4/26 15:06
|
|||
Thanks Brian
|
||||
|
Re: Rattle
|
||||
---|---|---|---|---|
Not too shy to talk
|
I know it happens in park not sure about when I'm driving.
Posted on: 2011/6/22 15:08
|
|||
Thanks Brian
|
||||
|
Re: Rattle
|
||||
---|---|---|---|---|
Not too shy to talk
|
Is sounds like its coming from the rear of the engine or tranny
Posted on: 2011/6/22 14:38
|
|||
Thanks Brian
|
||||
|
Re: Manifold heat valve
|
||||
---|---|---|---|---|
Not too shy to talk
|
My guess is the shaft is bent or worn. Thats why I'm replacing everything eventually. I`ve wired the counterweight in the down position and the temp seems to be ok
Posted on: 2011/6/22 14:29
|
|||
Thanks Brian
|
||||
|