harmonic balancer
|
||||
---|---|---|---|---|
Just popping in
|
how do I remove the harmonic balancer on a '29 standard 8 engine. the only thing I see inside is the gizmo for the hand crank. is there a special tool. if so where can I get one?
Posted on: 2015/4/18 13:27
|
|||
|
Re: 29 packard generator
|
||||
---|---|---|---|---|
Just popping in
|
the flange sits cockeyed in the housing by about a good half inch when you try to push it into the housing. I did not know there is a spring in front of the sprocket. with your info I'll bet that spring is out or sideways or something which means I will have to pull the timing cover???
Posted on: 2015/4/15 19:50
|
|||
|
Re: 29 packard generator
|
||||
---|---|---|---|---|
Just popping in
|
hello; the sprocket is still in the chain & the bronze flange goes into the sprocket but it will not seat flush in the crank case housing. nothing dropped down out of the chain.
Posted on: 2015/4/15 17:08
|
|||
|
29 packard generator
|
||||
---|---|---|---|---|
Just popping in
|
I have a '29 Packard standard 8. I removed the generator & while doing so the bronze flange pulled back a little bit. it did not come out. when I push it back in it will not seat flush. seems like the sprocket is not sitting in the timing chain correctly. I hope I don't have to pull the front off. help. thank you
Posted on: 2015/4/15 16:13
|
|||
|