Re: 46/47 bumper extensions
|
||||
---|---|---|---|---|
Not too shy to talk
|
Got a picture of the extensions?
Rob
Posted on: 2021/2/6 13:56
|
|||
|
Re: 46 limo lenght
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks H
Posted on: 2013/7/19 21:52
|
|||
|
40-42 Super Custom fan belt
|
||||
---|---|---|---|---|
Not too shy to talk
|
Interesting x reference for 356 fan belts.
Holdfast 426 crosses to 40 - 42 Custom and Super and several other truck and tractor applications. Another possible that x ref is Dunlop V155 NN.
Posted on: 2011/12/5 17:29
|
|||
|
Re: Mounting Autoloite Generator
|
||||
---|---|---|---|---|
Not too shy to talk
|
Thanks for comments guys.
I read some other posts and I suspect what I have is a job done long ago where a longer belt was used and the original adjustment arm replaced to make for additional lenght and bent for the missing spacer. To further compound the problem the pulley center has been rounded out and is no longer pressed on the shaft. To mount the pump I had to bolt up the fan , pulley and water pump as one unit and slide it in place then start the bolts. That was a chalenge . The pump, pulley, fan aside I am still am puzzled about the gap between the generator mounting bracket and the ears of the case. I pulled a stock autolite case that I have and measured it against the one I have. They are identical in lenght with exception of a circular indention in the ears of the non stock generator about the thickness of one 3/4 inch washer. I suspect that I still have the incorrect mounting plate. Mine measures 5 3/4 long. Does anyone have to compare that lenght to?
Posted on: 2011/12/5 16:16
|
|||
|
Mounting Autoloite Generator
|
||||
---|---|---|---|---|
Not too shy to talk
|
I just finishing doing a coolant system flush on my 2103 and am mounting the fan belt over the generator pulley wheel.
I was having difficulty and noticed that the ears on the generator case didn't fit properly between the front and rear mounts. The rear mount is a flat piece of stock with a 90 that bolts up to the block. There was a gap about 3/8 inch that was filled up by some washers. Does the rear ear fit behind or in front of the rear mount? Mine seems to go only one way with the rear ear behind the mount but that doesn't look right. Does anyone know its it in rear ear fits in front , behind or in between the mounts? Thanks Rob
Posted on: 2011/12/3 14:36
|
|||
|
Re: Spark plug wire lenght
|
||||
---|---|---|---|---|
Not too shy to talk
|
I found a vendor listing a made up set for all 46-50
8 cylinder Packard. I am darn sure that the block lenght is different for small eight and later series didn't have the coil through the firewall. His set has the lenghts 11", 11", 12", 13", 16", 19", 22", 26" and the coil wire is 13" I was hoping to get a set already made up. Do you know if factory leads were 90 degrees to the plug Rob
Posted on: 2011/1/30 12:43
|
|||
|
Spark plug wire lenght
|
||||
---|---|---|---|---|
Not too shy to talk
|
Does anyone know the factory spark plug wire lenght for the respective cylinder leads for a 47 Super (356)
Posted on: 2011/1/24 22:03
|
|||
|