Packard Forum Index » Pre-War (1899-1942)

Hi all
I am looking for an end car for the Owen Dyneto Type CE generator on my 1923 Single six. I have never had or seen one but assume that it carries adjustment for end float of the commutator. even a photo of one would assist if I have to make one.

Bernie J.

<two_oldlags@optusnet.com.au>

Hello
Having had the generator totally dismantled and rebuilt it ( new brushes etc) I have decided that the end (cap) plate that I referred to is a simple flat plate with four screws locating it. This being so I decided the simple answer was to make one.
Job's done!

Thank you for all your interest.

Bj