Packard Forum Index » Pre-War (1899-1942)

I'm in the process of installing a new wiring harness from Potomac Packards. It is going in nicely, but I need some help. The previous owner replaced the original wiring with odds and ends of spliced wire, run all over the place and so doesn't give much of a clue what is correct. Most of the routing I have been able to figure out, but the problem area is the wiring from the left hand side lights back to the dash. He had it running between the metal on the fender splash pan and the frame. I don't see where the wiring should go. Anyone have any photos or suggestions?

Thanks

David, the engine compartment wiring loom on my 115C Convertible Coupe runs along the top of the frame rail next to the lower edge of the splash panel on the LH side. The car is not in the garage right now so I can't get you a photo. I hope this helps.

(o{}o)

that helps thanks!

The main issue is where does the wiring harness enter the engine compartment from the fender?

David, on my 115C the wiring loom enters the engine compartment low on the LH side. It is a replacement loom installed by one of the previous owners.

(o{}o)

Thanks - I'll go crawl under the car and see if I can find the opening.