Packard Forum Index » Pre-War (1899-1942)

Hey Guys,

Working on a 1941 180 super 8 here..

Quick Question. I got my clutch linkage back in, and went searching in my parts for the clevis pin to hook up the pedal to the relay rod, and I have one that is the right diameter, but can't find one long enough. No - big deal, right? I grab one from the hardware store of the same diam of my 'test clevis' (3/8's seemed about right), but it's too big. So I get around to measuring and kinda think the 'correct' diameter is actually 11/32.

Can anyone confirm this clevis pin is supposed to be 11/32" diam (see picture)?

Where can I source an 11/32 diam clevis pin? It seems like a really odd size (McMaster and grainger don't seem to have any?

Attach file:

---

  (340.90 KB)

Answered my own question....

I got to thinking after I posted, and it turns out there are 2 holes drilled in the pedal side were the clevis pin is inserted. Turns out the cotter pin goes through one side of the pedal cast portion, the clevis pin, then out the other side of the clevis cast portion...I'll post a pic in a minute

see attached pic. Simple enough when you see it together...

Attach file:

---

  (289.08 KB)