Re: 53 Clipper 2 door post
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
"yes I'll add to the registry!"
Mike, ![]() ![]()
Posted on: 2015/5/18 2:22
|
|||
Mal
/o[]o\ ==== ![]() Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? ![]() Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: 53 Clipper 2 door post
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
If your going for a black exterior. How about the 1952 ebony gold paint. It was supposedly a paint option but it seems very few were actually painted. It is in the 1952 spec book. Good luck with your rebuild!
Posted on: 2015/5/18 10:55
|
|||
"Do you ever think about the things you do think about?"
Inherit the Wind |
||||
|
Re: 53 Clipper 2 door post
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Other than finding a donor car with better metal that has been wrecked or already been parted, I think your only option for any new metal is Classic to Current.http://www.c2cfabrication.com They may not have everything you need though. If the model is one not that common or popular you may have to buy a panel that looks close and then customize farther.
As others will attest, for the most part C2C's panels are not direct weld in replacement pieces but are starting points for the shape needed in a location and will need tweaking.
Posted on: 2015/5/18 11:57
|
|||
Howard
|
||||
|
Re: 53 Clipper 2 door post
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Ebay had floor panels from time to time-may be from C2C. There have been several posts regarding this subject as HH56 states they require some modification
Posted on: 2015/5/18 12:48
|
|||
|
Re: 53 Clipper 2 door post
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
The panels work, but they are "generally" the right shape and pattern. But not perfect drop in replacements. The panels are not stamped like Packard did them. So for example, the transition between the floor pan and the kick panel is a sharp bend done on a brake, as opposed to at radiuses bend as done on the original Packard stamping.
So be prepared for some hammering, shaping, trimming, and copious cursing. or at least that was my experience with the front floor panels on my '54 which is probably the same panels as your '53. A pneumatic body hammer for shaping the sides and front really helps. See my project blog to see what I had to do to get them to fit. If you have any rust in the trans tunnel, be prepared to buy extra 18ga steel to make you own patch panels. But all said and done, they do give you the quickest path to a floor replacement besides cutting up a donor car.
Posted on: 2015/5/18 13:23
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|