rear hub caps
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
I keep losing rear hub caps when crosing ripple strips on my 47 clipper any solution
Posted on: 2021/5/26 6:49
|
|||
|
Re: rear hub caps
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
Thanks I will give a try
Posted on: 2021/5/26 18:23
|
|||
|
Re: rear hub caps
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
There was also a factory service suggestion for ensuring that the wheel clips would hold the hubcaps securely.
https://packardinfo.com/xoops/html/downloads/SC/SC-VOL22NO2.pdf
Posted on: 2021/5/26 19:11
|
|||
|
Re: rear hub caps
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks for that service letter. It gives the specs and the means to correct the problem.
After I lost a cap, I was advised to apply friction tape. I added it to the prongs and have not lost a cap since. Maryland freeways, especially around Baltimore, have huge, dangerous potholes, big enough to bend a rim. Coming back from Annapolis on Tuesday, I hit a wide deep chasm of one I didn't see in time to avoid. But this time the cap held. Since Kanter sold out of the hexagon/script reproduction caps, I've bought a few used back ups. I wish they would make another 200 because I'd get 4 to keep on the shelf for showing the car.
Posted on: 2021/5/27 8:23
|
|||
|