Re: Ultramatic leak Re: Backward Speedometer gear
|
||||
---|---|---|---|---|
Forum Ambassador
|
From the way the article in SC Vol 27 #11 reads I would say yes. It will mean holding the trans and engine up with a jack while you remove the rear crossmember and tail shaft to access the parking gear and drive gear. In lieu of using a jack to hold the engine and trans you could also make a version of the holding bar as described in SC Vol 24 #6 with the longer screws as mentioned in SC Vol 25 #10.
Posted on: 2023/6/2 10:39
|
|||
Howard
|
||||
|