Re: 1955 Packard Door handle kepps falling off ARRRGHHH!
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
There is a different part number for 55 handles and retainers and 56 handles and retainers so that makes for an interesting question. Question would be if there was an actual physical difference in the parts or was it just the part number changes they were in the process of updating to integrate with Stude. 55 has the old 6 digit part numbers and the 56 has the new 7 digit numbers. Looking at some spare handles which am reasonably sure are of mixed years I do not see an obvious difference in them. That single different clip was inserted in one of the bunch.
There was a documented change in the clip for the 55s so perhaps that is the two black clips with different openings in the photo in post #8. I wonder now if that other clip with the solid back and heavier construction might have been a change for 56. If so it must have been later because my 56 had the type with openings. It will be very interesting to see what they send you.
Posted on: 2014/7/4 10:16
|
|||
Howard
|
||||
|
Re: 1955 Packard Door handle kepps falling off ARRRGHHH!
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Well the used clip they shipped seems to be doing the job. It had looked like it would need to be adjusted for firmer engagement but it was decided to put it on just as received. After several road miles and the better half shutting the door "robustly" (seemingly testing the poor clip) it is holding so price is a little less of a sting.
Posted on: 2014/8/27 14:37
|
|||
|
Re: 1955 Packard Door handle kepps falling off ARRRGHHH!
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Good to hear. These are the 3 versions that have been found in handles. Do you recall which version of the clip they might have shipped?
Attach file: ![]() ![]()
Posted on: 2014/8/27 14:53
|
|||
Howard
|
||||
|
Re: 1955 Packard Door handle kepps falling off ARRRGHHH!
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Believe it was the middle one in your pic though the bottom 2 look similar. I will keep the original one in the bag with all original clips/parts which did not get reused
Posted on: 2014/8/27 16:47
|
|||
|
Re: 1955 Packard Door handle kepps falling off ARRRGHHH!
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
This is like the gift that keeps on giving!
I solved my door handle problem through an exasperating series of trials and errors, I finally found a solution that has been working for more than a year (no, really). Along with a rather weak clip, I lodged a piece of felt into the gap and drove the concoction home by gently tapping the handle with a rubber mallet. I know it sound bizarre, but it seems really seated in there now and hasn't budged one bit since I did my magic! ![]() ![]() ![]() ![]() ![]() As I always say, if you keep banging your head against a wall, sooner or later you will successfully put it through. Ignore the throbbing headache ...
Posted on: 2014/8/27 17:16
|
|||
You can make a lot of really neat things from the parts left over after you rebuild your engine ...
|
||||
|