Packard Forum Index » V-8 (1955-56)

Topic: T'Packman or other Hash engine owners

Bottom

Previous Topic

Next Topic Register To Post

PackardV8

T'Packman or other Hash engine owners

Home away from home

Can anyone verify if the Hash engine has a CAST Iron or STEEL cam shaft?????

Posted on: 2008/10/16 14:11

VAPOR LOCK demystified: See paragraph SEVEN of PMCC documentaion as listed in post #11 of the following thread:f
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7245

Eric Boyle

Re: T'Packman or other Hash engine owners

Home away from home

I can tell you that it's made from a ferrous metal, but that's about it. I only have one out, it's 130 miles from me, and I might have tossed it, as two of the cam lobes wore so bad that they were perfectly round and destroyed the valve seats on those two valves. The valves were at least a 1/4" UNDER the seat area on the head.

Posted on: 2008/10/16 20:20

mikec

Re: T'Packman or other Hash engine owners

Home away from home

you mean Nash right??

Posted on: 2008/10/16 22:16

Daily Driver:

Jack Vines

Re: T'Packman or other Hash engine owners

Home away from home

hi, mike,

hash is the shorthand used here for the 1955-early '56 Hudson and Nash which had the Packard V8.

thnx, jack vines

Posted on: 2008/10/16 22:28

Eric Boyle

Re: T'Packman or other Hash engine owners

Home away from home

Yes, and it's better than saying "Nudson".

Posted on: 2008/10/17 0:28

PackardV8

Re: T'Packman or other Hash engine owners

Home away from home

T'Packman wrote: " as two of the cam lobes wore so bad that they were perfectly round ..."

Let me guess, it 's the 2wo lobes nearest the front of the engine and furthest away from the oil pump???? Quite possible then it is a steel cam

Posted on: 2008/10/17 10:36

VAPOR LOCK demystified: See paragraph SEVEN of PMCC documentaion as listed in post #11 of the following thread:f
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7245

Eric Boyle

Re: T'Packman or other Hash engine owners

Home away from home

I wouldn't say that they're the furthest away, but they're up towards the front if I remember right. If it matters, this engine was run as an irrigation pump engine using propane.

Posted on: 2008/10/17 13:01

Board index » Discussion » V-8 (1955-56) » T'Packman or other Hash engine owners

Top

Previous Topic

Next Topic

	';
Hello and welcome to Packard Motor Car Information! If you're new here, please register for a free account.