Re: Clutch Change 53 Clipper 288 Engine
|
||||
---|---|---|---|---|
Home away from home
|
There is no seal in the front of the trans, there's a reverse spiral on the input shaft that brings any leakage back in. The rear eng crank seal is independent of the trans. You may want to buy a throwout brg spring (tiny) as it sometimes gets overstretched when removing. Otherwise it's the same as any other car
Posted on: 2017/5/8 21:20
|
|||
|
Re: Clutch Change 53 Clipper 288 Engine
|
||||
---|---|---|---|---|
Home away from home
|
Thanks for that information. Is the rear engine seal something that can be replaced during a clutch change?
Posted on: 2017/5/8 21:25
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|
Re: Clutch Change 53 Clipper 288 Engine
|
||||
---|---|---|---|---|
Forum Ambassador
|
Steve, the rear main bearing seal is accessed via the oil pan, not the clutch housing.
Posted on: 2017/5/8 22:25
|
|||
|
Re: Clutch Change 53 Clipper 288 Engine
|
||||
---|---|---|---|---|
Home away from home
|
Good advice from previous posts. Don't forget to check the condition of the pilot bearing. JWL
Posted on: 2017/5/9 10:14
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|