Re: 1948 Front Motor Mount
|
||||
---|---|---|---|---|
Forum Ambassador
|
Have you removed the bolts that hold the yoke to the crossmember?
Posted on: 2019/4/10 10:17
|
|||
|
Re: 1948 Front Motor Mount
|
||||
---|---|---|---|---|
Quite a regular
|
I haven't done that, good suggestion. I will try that over the weekend and see if that does the trick. thank you
Posted on: 2019/4/10 10:42
|
|||
|
Re: 1948 Front Motor Mount
|
||||
---|---|---|---|---|
Quite a regular
|
Worked on the car yesterday afternoon and was able to remove the motor mount and clean up that area. Removed the grill and pulled the distribution tube , it came our easily and was not plugged up. Over the next few days I will start the re-assembly. I am taking the radiator to a shop to have them take a look and see if it is plugged. It does not leak but since it is out I figure I should have it looked at. The water pump bearing was worn out and the car always ran on the hot side, around 190. I checked it with an infrared thermometer and didn't find any hot spots. Front to back and the radiator all seemed the same. I'm hoping the new water pump will allow it to run cooler. I will check the thermostat as well. I did replace that a few years ago. I appreciate any suggestions, thanks.
Posted on: 2019/4/15 11:26
|
|||
|