Packard Forum Index » Post-War (1946-54)

Can anyone tell me what type pin or bolt goes through the top cylinder yoke that holds the rear arms in the yoke as mine were missing?? Would it be the same type pins that hold the side rails & other arms on the side rails with cotter pins? One picture I was looking at seemed to be a bolt but I don't know if that is correct?? Thank you!!

On my 1954 Convertible it is fastened by a 3/8 diameter bolt with a 9/16 hex head, about 1 1/4 inches long. The nut is placed on the outside. The picture is of the right side.

Attach file:

---

  (126.88 KB)

Thanks so much for the picture Don!!!!

Glad to be of help, Packman!