Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
From the bottom, remove the single screw which holds a tab extending from the inside of the chrome ring. Gently separate the chrome ring from the tail light body at this bottom point, then lever it up as there is a slight metal tab of the tail light body which is wedged under the chrome ring at the top. If yours is fighting, its likely due to rust of the tail light body holding the ring tight to the body. The chrome bezel is brass, not gonna rust, but as these tail lights rust around the body/ring edge, they do get kinda stuck together. Just go at it gently, and you'll succeed.
Posted on: 2012/7/6 22:26
|
|||
|
Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
My crome rings do not have screws in the bottom they have what looks like a blind rivet head. The ring will twist very slightly.
Posted on: 2012/7/6 22:34
|
|||
|
Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
The blind head rivet is in the ring. it holds the tab I refer to that is screwed though the bottom of the tail light body, about 1/4" in, with a slotted screw. If this screw has already been removed, then all you need to do is pry the ring out at the bottom, near this rivet and up and off it will come.
Posted on: 2012/7/6 23:33
|
|||
|
Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
Thanks for the info I will try it in the next few days.
Posted on: 2012/7/7 0:07
|
|||
|
Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Since your tail lights are off and apart, now is the time to install some aluminum foil, shiny side out behind the bulb. I did this in my '47 Super after noting some Cord friends doing it in their funny-looking jalopies. I detest urban light pollution as much as human overpopulation, but anything you can do to enhance our old cars' tail lights is a prudent idea.
Posted on: 2012/7/7 3:50
|
|||
|
Re: 1937 115C tail lights
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
I finally did get the tailight lenses off and as priviously suggested the screw holes had been filled in. I think I will drill new holes and install a dromed screw. I think it will secure the lens and ring better. Thanks again.
Posted on: 2012/7/8 15:08
|
|||
|