|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
Why aren't you considering just replacing the bad gear or gears in the current transmission?
Posted on: 2013/9/9 22:42
|
|||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Quite a regular
 
|
That I have but it could be more convenient to take the 48 tranny and swap with the broken one. I saw two teeth missing on the second gear so I suppose I can replace that one gear.
Anyway thanks for the suggestion.
Posted on: 2013/9/10 1:04
|
|||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
A 54 R11 tranny bolted right up to my 38.
Posted on: 2013/9/10 8:00
|
|||
|
1938 1601 Club Coupe
|
||||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Home away from home
|
fogfather - I believe any of the '39-'54 Packard transmissions (excluding the '39 Twelves and Super 8s) will bolt up to your '40's 110 engine. The back end of the transmission is another story. You may need to swap output shafts and tail housings. Also, not sure about this but the rear mounts may be different. If I recall correctly, some had mounts on the sides of the transmissions and others had them on the tail housing. There are parts books here which you can download to do research. I have not had any direct experience in doing this, but most probably there are folks here who have and can offer advice based on their experiences.
(o{}o)
Posted on: 2013/9/10 11:10
|
|||
|
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
One question I'd have being a 110 is if a senior trans would bolt right up. Isn't there an input shaft size difference so possibly a different pilot bearing and clutch plate would also be needed.
Posted on: 2013/9/10 11:28
|
|||
|
Howard
|
||||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Quite a regular
|
Thanks so much for the information and advice.
Posted on: 2013/9/10 11:29
|
|||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Home away from home
|
Howard - Good point. The senior cars used an 11" clutch and I don't know if the 110 flywheel is drilled to accept the larger unit. Also, for fogfather to consider, is the mix of overdrive and non-overdrive transmissions.
(o{}o)
Posted on: 2013/9/10 17:37
|
|||
|
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Home away from home
|
Just want to say I appreciate everyone's comments as well as the transmission in my 40 110 tends to jump out of first gear and I could have asked almost the exact questions and had the chance to pick up a 48 transmission recently.
Jim
Posted on: 2013/9/10 17:54
|
|||
|
||||
|
Re: which transmissions are interchangeable with a 40 110
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
There's a '41 110 non OD trans on eBay.
Posted on: 2013/9/11 0:56
|
|||
|
Mal
/o[]o\ ====  Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this?  Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
||||
