Re: Heater/defroster plumbing
|
||||
---|---|---|---|---|
Forum Ambassador
|
If flackmaster doesn't have something and since it is high and well out of sight perhaps it could be fabricated. IIRC someone said it was essentially a bent piece of sheetmetal with a collar on one side for the duct. I believe it was even described as being somewhat crude.
If someone could post dimensions or maybe a photo or two of a real one taken straight up under the dash to see where or how things lie and mount, it might be able to be done for a reasonable cost at a sheetmetal shop -- or even in your garage.
Posted on: 2016/3/27 11:53
|
|||
Howard
|
||||
|