Re: helping a friend locate an exhaust manifold for a 37 120
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
When you find a used one, it will probably be warped as well and require surface grinding to correct. And repairing the heat riser valve isn't usually much of a challenge. You may be better off with the one you have?
Posted on: 2019/5/3 9:55
|
|||
|
Re: helping a friend locate an exhaust manifold for a 37 120
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Don - I have NOS heat riser flaps and shafts if you go that route. If the manifold ain't cracked, should not be a headache to restore...and yes to suggestion to have it faced - good seal for fresh gaskets anyway.
Posted on: 2019/5/3 10:06
|
|||
|
Re: helping a friend locate an exhaust manifold for a 37 120
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Would you have the weight that's attached to the shaft on the manifold side for a 1938, 120 8 cyl? Don't know if it's the same as the 37?
Posted on: 2019/11/28 1:23
|
|||
Tony
|
||||
|