Packard Forum Index » Project Blogs

This is what I'm planning for valve seal. Not a seal . but keep oil on guide from dripping on stem and getting sucked up.

Use silicone hose. Have hose past end of guide by inch or so. So it doesn't get hit when valve is lifted.

I could put a seal on stem. But inside hose might pull hose .

The hose is pushed all the way up. Guide.

5/8s id. vinyl. Hose fits tight on original guide.
.

Chevy valve seal. Think it's to going to be to tight on Packard valve stem.

Attach file:

---

  (274.62 KB)


  (254.85 KB)

youtu.be/bMnxRy2DCz4

Ross. Ultra assembly

youtu.be/1gRZ6nadptg

Ultra turbine

youtu.be/viaajKAsBPY

Reactor shaft.

Shaft clearance. Part 1

youtu.be/UNbjh_4eYF4

Part 2. Last video ..so that's where you add.

youtu.be/0iDmQ-AFFTs

These are one piece. And heavy duty.. Cam bearings.

Attach file:

---

  (97.93 KB)

On a new mission.. Bonding cork rubber type. To DD.

The type out there to me is to hard. Ross sparked this.

Anabond so far is only in India. MC master carr has this pliobond. Up to 500 degrees.


This stuff going to try on headlining.

talbrossealing.com/cork-friction-material/

Attach file:

---

  (287.51 KB)


  (280.12 KB)