(9.28 KB)
|
Re: DXF-file of the Packard-logo?
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
What is your intended usages and did you obtain clearance to do so? I believe have one I created that I can send although it's slightly different than your sample. It's actually an eps but should load into any program that can handle a dxf. PM me with your direct email address and if I can locate it, I'll send it off to you!
It is this style (this emblem was all eps): Attach file:  (122.16 KB)
Posted on: 2020/1/12 12:20
|
|||
|
||||
|
Re: DXF-file of the Packard-logo?
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
2470Packard, the Packard script is trademarked and owned by The Packard Club. As Don noted, depending on your intended use you may need to obtain permission to use the script.
Posted on: 2020/1/12 13:08
|
|||
|
||||
|
Re: DXF-file of the Packard-logo?
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
The script/style shown in the opening post (packard7.jpg) was used by The Packard Electric Company - not PMCC.
Posted on: 2020/1/12 13:35
|
|||
|
||||
|
Re: DXF-file of the Packard-logo?
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
Thanks BH, I was unaware of that. Is that trademark no longer protected?
Posted on: 2020/1/12 13:38
|
|||
|
||||
|
Re: DXF-file of the Packard-logo?
|
||||
|---|---|---|---|---|
|
Home away from home
|
I'm not a trademark expert but I would think it to be close enough to Packard's design to not matter much. Anyway, the OP has no commercial intentions.
Posted on: 2020/1/12 13:54
|
|||
|
||||
