Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
NApa sender works. For how long ?
Had to use street 90s This delco distributor. Oil tube the curve is to wide
Posted on: 2021/11/13 0:26
|
|||
Riki
|
||||
|
Re: RIk
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Ready for testing.
Still need to make up the relays. Attach file: ![]() ![]() ![]() ![]() ![]() ![]()
Posted on: 2021/11/16 22:40
|
|||
Riki
|
||||
|
Re: RIk
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Another done.
Smooth.. To get window out. Stuck up. Remove regulator bolt and unscrew motor. Motor / regulator will drop down. Then you can get to window clips. Packard motor shorted .. Attach file: ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
Posted on: 2021/11/19 19:49
|
|||
Riki
|
||||
|
Packard 12 rod beating inserts
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Drilling holes for new bearings
Bottom picture is new rod and insert I drilled. New rods holes are in center of rod. The small hole is 60 degrees off center. The jig. I think my dad made for getting Babbitt off of copper. Still need to put a fillet on the little hole Attach file: ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
Posted on: 2021/12/1 15:41
|
|||
Riki
|
||||
|
Re: Packard 12 rod beating inserts
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Here is the photo with sender trunk hole dimensions Ross provided and is applicable 51-56.
Posted on: 2021/12/1 17:06
|
|||
Howard
|
||||
|
Re: RIk's 56 ultramatic
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks h.
Posted on: 2021/12/1 17:11
|
|||
Riki
|
||||
|
Re: RIk
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Posted on: 2021/12/22 23:19
|
|||
Riki
|
||||
|
Re: RIk
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Lower A arm
I know they were my camber problem. Now to get them out. Can't press them out. It was my squeak too. Inner but was loose.
Posted on: 2022/2/12 16:39
|
|||
Riki
|
||||
|
Re: RIk
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
if the axle is moving, you can get the bush out with crowbar.
Posted on: 2022/2/14 7:15
|
|||
|