Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thank you.
I looked in the Body chapter, gave up, and posted here.
Posted on: 7/20 21:28
|
|||
Stewart Ballard
|
||||
|
Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Some time ago I replaced the fresh air fan (under the right side horn) with a modern motor. I am just now getting around to wiring it up. The fan switch in the photo may be broken. It does not stop at Off, High, or Low. It just spins and moves in and out with no resistance, Is that normal or do I need to replace it?
I have the rear bumper ready to bolt on but one of the tailpipes is not like the other. It is angled a few degrees upward so I have to bend that pipe first. Attach file: ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]()
Posted on: Today 13:45
|
|||
Stewart Ballard
|
||||
|
Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
The switch is broken and needs replacing. Shaft should not slide in or out and there are 3 distinct detented positions. Something internal has broken to permit the rotation and shaft movement..
Posted on: Today 14:04
|
|||
Howard
|
||||
|
Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Adding to Howard's response:
The switch can easily be disassembled by gently prying away the two tabs on the back. Even if you buy a new switch, I suggest you do this and lubricate it. The difference is very noticeable and well worth the 5 minutes of effort.
Posted on: Today 17:58
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks for the info.
I just bought a replacement switch off eBay and am pretty sure it is coming from Gerry in San Diego. I also pulled the front bumper out of storage today. I am glad I decided not to spend any money on the rear bumper at this time. The front bumper is in worse shape. The lower section is bent badly and needs a complete replacement. Also, the right side bullet has rust holes through it. Attach file: ![]() ![]() ![]() ![]() ![]() ![]()
Posted on: Today 18:20
|
|||
Stewart Ballard
|
||||
|
Re: Stewart's 1955 Packard 400
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Mike at Tucson Packards just recently got in several large shipments that included some nice bumpers so you might check with him. When I had one of my own straightened and replaced last year, it cost $1000 and wasn’t nearly as bad as yours (just a few jack marks) so keep that in mind with the cost of a good replacement.
That said, the one in your photo appears to be 1956 but I will have a straight 1955 bumper available soon. Although the lower piece needs replating too, it is otherwise very straight.
Posted on: Today 19:40
|
|||
|