How to remove grille for plating
|
||||
---|---|---|---|---|
Just popping in
|
I am looking to rechrome the grille from my 37 Super 8. I would appreciate any instructions on the process. Thanks
Posted on: Yesterday 21:28
|
|||
|
Re: How to remove grille for plating
|
||||
---|---|---|---|---|
Webmaster
|
You'll need to pull the front radiator shell off. While you maybe able to try to finagle it off, it's usually easier to pull the entire front clip off to do it.
That involves removing the bolts holding the rear of the fenders to the cowl and the rubbing boards. Also removing the bolts from the brace between the frame rail and the fender directly behind the wheel well. In the front there is just the large center pivot bolt under the radiator, and the rods between the radiator and the firewall and the front bumper and brackets. Obviously you'll need to drain and remove the radiator hoses, and unhook the headlight wiring, and remove the inner fender panels before hand. They you can either use a engine picker or grab a couple of buddies and pull the entire clip up and forward off the car. With the clip off you can also take care of any engine cleanup and maintenance issues. Anyway, once then clip is off, then you can remove the radiator from the shell and will have access to the grille itself. It was sure not a part that Packard thought anyone would need to replace....easily.
Posted on: Today 7:49
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|