Packard Forum Index » Project Blogs

Ohh this is thr 1937 thread. Wasn't paying attention 🙄

Looking for a source for these window channel felts which is used on rear channel of the convertible doors. The edges appear to use a felt with a square profile. The pads on bottom of the channel are flat.

I simply used 1/4" felt from the material store and cut new pieces using one ragged remnant that was the closest to intact as a pattern, then tucked them back into the window guide frame pockets. Being an anti-rattle it is never seen, so the colour is not an issue, though I used natural, and the new felt works quite well. Sorry, it was an area I did not take a picture of and is now buried in her door assemblies.
Bob J.