Re: 1951 Shudder on acceleration.
|
||||
---|---|---|---|---|
Home away from home
|
Considering just one of several possibilities Dave . . . Seems likely you'll have to replace your oil seals in the rear axle housings as that would account for the leaking diff oil (- if you are certain it is diff oil, and not brake fluid -??). Rear wheel bearings might be OK, with just the seals worn out.
It's possible that the 'shudder' could be related to these leaks. The rear brake shoe material can expand and grab when it gets soaked by either oil or brake fluid, and the expanded shoes could be grabbing the drum causing a mild shudder, which would be worse at low speed. If the brake shoes have been affected by oil you'll need to replace them. The idea is to isolate one problem, fix that, then maybe the chirping will also go. Dunno much about Ultramatic problems, however it's possible that inconsistent/varying load on the Ultramatic might be causing the noise. There are a good many people on this forum that will have some additionalideas.
Posted on: 2011/11/2 17:03
|
|||
1951 Packard Club Sedan | [url=ht
|
||||
|
Re: 1951 Shudder on acceleration.
|
||||
---|---|---|---|---|
Home away from home
|
is there a fluid puddle under where the car was parked?
a pint of transmission fluid covers 7 square feet ,the fluid is red dyed .The ultramatic can have a slow leak from the pan gasket, and from the bushing where the shift selector rod goes in to the case where theres a bushing that can wear out .low fluid levels can cause a chirpy noise . to check the fluid level ,,the easiest way is up on a lift... if you dont have a lift you can do it from the iside of the car; driver side pull back the back edge of the carpet or mat theres two holes ;the one on the top of the hump in the midline is the filler hole ,and the one on the driver side of the hump is over the dipstick .its a bit hard to reach
Posted on: 2011/11/2 23:20
|
|||
|
Re: 1951 Shudder on acceleration.
|
||||
---|---|---|---|---|
Just can't stay away
|
Had a shudder on hard acceleration on my 51 but didn't seem to do the same on deceleration. Turned out to be a worn trunnion universal. The housing was worn quite badly. Rear end oil leaks are just that. Check for leaking axel seals and for leaky brake cylinders. If the diff fluid has leaked out due to bad axel seals the gears will be damaged, and hence, make noise. Check the fluid level. Theres more to it but that is a place to start.
Posted on: 2011/11/3 12:20
|
|||
|
Re: 1951 Shudder on acceleration.
|
||||
---|---|---|---|---|
Forum Ambassador
|
In addition to a worn ball & trunnion front joint which is a good possibility, other possibilities for chatter on acceleration are dragging or misadjusted low and/or reverse transmission bands, and possibly worn or distorted high range clutch plates.
Posted on: 2011/11/3 13:18
|
|||
|