Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
If you hook your remote starter switch to these two terminals when you press the switch it will energize the solenoid, which in turn will energize your starter.
![]() On the farm we just used a screwdriver, or whatever we could find to jump the starter. LOL
Posted on: Yesterday 22:11
|
|||
|
Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Got it. I was going from the positive terminal. I'll try that.
Fuel lines are all on. The new filter I ordered doesn't seem to be the correct thread size so I used the old one after cleaning it. Filled tank with five gallons of non ethanol rec fuel. Replaced coil. I'll need to get a different bracket or grind the old one off the original. Pulling the plugs next. Just labled the wires. Then time to crank - hopefully with remote starter.
Posted on: Yesterday 22:25
|
|||
|
Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Using the Positive terminal is what would normally happen, but our cars are Positive ground.
There shouldn't be any reason that you fuel pump isn't going to work just fine, but good to verify. Check to make sure you have spark at on of your plugs when you have them out. Key will need to be on to energize the coil. Once you have fuel and spark you should be good to go! I think you're close!
Posted on: Yesterday 22:35
|
|||
|
Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Pulled plugs, ran remote start, cranking...and we have fuel pumping through the filter. Time to reinstall plugs and check spark.
Posted on: Yesterday 22:40
|
|||
|
Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Yay!
You can just connect a spark plug while it's out and with the key on and the spark plug grounded you can see if there is spark. Hopefully a bright blue spark. Keep your battery well charged while your working in your car.
Posted on: Yesterday 22:44
|
|||
|
Re: 1954 Packard Clipper Deluxe - No Start. Need guidance/assistance.
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
I used an inline spark tester and I don't have spark on cylinder 1 or 2. Didn't check the others.
I have a fuel leak on the line running to the carb at one of the connections. I'll have to address that and spark in the morning. On the charger when not being turned over. Thanks for the tip.
Posted on: Yesterday 23:04
|
|||
|